Reliable Data-Logger DL-04 Manuel de l'opérateur télécharger pdf (Page 36)

Q-DL-2100 Operatorʼs Manual

Quaesta Instruments, LLC (520) 449-3806 • Email: support@quaestainstruments.com

Step 6. Configuring the Serial Port parameters.

Select Setup->Serial Port from the main menu.

a. If using the dataloggerʼs USB COM port, configure the parameters as in

Figure B-14. *Note that the Port number selected must match the

dataloggerʼs USB Virtual Serial port number as found in Appendix A,

Step 3.

b. If using one of the dataloggerʼs RS-232 interfaces for the Terminal

connection available via the RJ45 connector labeled RS-232 on the

datalogger backpanel, configure the parameters as appropriate. In this

case, the INI parameters “UseRS232” and “UseSatModem” must be set to 1

and 0, respectively. The baud rate defined by the INI parameter

“RS232BaudRate” should then be used in the RS232 port configuration.

Figure B-14.

One may save and restore Setup parameters by selecting the appropriate commands from

the Setup menu.

1 2 ... 31 32 33 34 35 36 37

Pas de commentaire

Reliable Data-Logger DL-04 Manuel de l'opérateur Page 36